Canadian Solar Inc., one of the world's largest solar power companies, today announced that its solar modules CS6P-P series (60 cells, polycrystalline ) and its monocrystalline MWT cell modules, ELPS CS6P-MM series (60 MWT cells, monocrystalline) have all passed Fraunhofer ISE's PID test in accordance with the draft IEC62804 (System Voltage Durability Qualification Test for Crystalline Silicon Modules).
The PID test assesses how well modules can withstand the degradation phenomenon known as Potential Induced Degradation (PID). For a module to pass the PID test, its power degradation must be less than 5% following the PID test. Following test conditions are applied:
CS6P-P series polycrystalline modules have a power range from 235W to 255W. ELPS CS6P-MM series monocrystalline modules cover power output from 260W to 270W.
Dr. Shawn Qu, Chairman and CEO of Canadian Solar, said, "Despite the highly rigid standards, Canadian Solar modules have been confirmed once again to be PID resistant. In 2011 and 2012, Canadian Solar modules had passed PID tests done by PI Berlin in Germany and PVLB in USA. This latest test further validates the premium quality of Canadian Solar's modules. We will continue to leverage our state-of-the-art PV testing lab as we work to safeguard the high-quality our solar modules have become known for worldwide over the past 12 years."
How does PID happen? How to prevent PID from happening?
According to general consensus among solar system experts, the major root cause of PID is the combination of high level humidity and heat in an environment where a solar system is installed. Various studies have shown, and been confirmed by several PV solar systems in operation, that in a solar power system with P-type (C-Si) modules installed in a hot and humid area without negative grounding, a negative bias will build over time inside the module, between its internal circuit and the frame, thus giving rise to the PID phenomenon. PID high-risk areas include desert areas, tropical regions and locations close to water.
There are several ways to lessen PID effects:
The most effective solution to PID problem suggested by PV system experts is to have negative pole grounding in the system installation. This way, the solar module array will have very high resistance to PID effect in a system.